Balancing that with its electronic speed control that maintains motor speed under load put us in the driver seat (okay, we’ll stop here with the sports car analogies). Fortunately, the tool has great control because all that power would be useless without being able to handle it properly. The GPH01D is the first tool we’ve tried in Makita’s new 40-volt XGT series, power tools with 40-volt motors but batteries that are the same size as a large 18-volt. Okay, it didn’t bore the most holes in this test, but it did get to its number faster than anything else. Knots don’t stop it and barely slow it down. So long as you keep that trigger pulled, it will just churn through hole after hole. Pull its trigger (floor it, if you will), and you just burn through one hole after another until the battery is done. Using this drill, you feel like somebody just tossed you the keys to their Ferrari. If you need this much power tool muscle you just need to have some muscle of your own. But as to the tool’s weight, we don’t count that as a mark against it. The other large-battery tools were the DeWalt (5.4 pounds) and the Makita (5.2 pounds), and these were also pro-duty, intended for either serious do-it-yourselfers or contractors. The FX1171T, with a 5-Ah battery, was the heaviest of the drills (5.8 pounds). You should know that this is clearly a heavy-duty tool intended for people who need maximum power and run time. We can’t fully vouch for that particular feature, but we can say that we pushed this Flex very hard and noticed no kick back the drill will pause momentarily if you really lean into it (call it a reset). The FX1171T blasted out its hole allotment, helped by its turbo mode setting that bumps up the top speed from 2,000 to 2,500 rpm.Īlso helping was the tool’s circuitry, which has an anti-kickback feature. We’ve tried a batch of these tools (drills, saws, rotary hammers and grinders) and find them to be formidable competitors in the professional segment. And when we say “muscling in,” we’re not kidding. And from what i saw a drill with a chuck key works better than one with a hand tighten chuck.Flex, short for Flex Elektrowerkzeuge, is a German power tool company muscling its way into the American market. Pretty sure that is why these are stripping out so easily. I think the entire thing is made of spring steel which seemed kind of crazy to me especially for the shank the drill goes on. I should have paid more attention to the low ratings on this. For $60 and a Klein i expected much more from this would not mind so much if this was not a $60 drill bit that wouldn't even complete one hole. Granted maybe i hot something and did this but still every other drill that happens it does not become impossible to remove from my experience and if it does they are cheap. I got sick of fighting what seemed like an impossible to win battle so had to cut it off with an angle grinder and cut off wheel. Could not even back it out with a hammer and vise grip or hitting down on the clamp on the handle of my hammer drill. Even tried 1/2 inch dewalt hammer drill in low and normal mode it would not turn this. First time used started fine then just stopped then started slipping in drill and would not budge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |